EasyManua.ls Logo

Zte ZXR10 2928 - Configuring RADIUS

Zte ZXR10 2928
341 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Chapter 8 Access Service
Confidential and Proprietary Information of ZTE CORPORATION 169
f Max-request refers to maximum times of request
resending when timer expires before authentication
system receives Challenge response from client system.
6. To display the 802. 1x configuration of the port, use
command show aaa-control port [<portlist>] in nas config
mode. This is shown in
Table 271.
TABLE 271 SHOW AAA CONTROL PORT COMMAND
Format Mode Function
show aaa-control
port [<portlist>]
nas config This displays the
802. 1x
configuration of the
port
Result: This displays the 802. 1x configuration of the port.
7. To display the 802. 1x protocol parameters, use
command show dot1x in nas config mode. This is shown
in
Table 272.
TABLE 272 SHOW DOT1X COMMAND
Format Mode Function
show dot1x nas config This displays the
802. 1x protocol
parameters
Result: This displays the 802. 1x protocol parameters.
E
ND OF STEPS
Protocol parameters or 802. 1x has been configured on ZXR10
2920/2928/2952.
Configuring RADIUS
This topic describes the RADIUS configuration of ZXR10
2920/2928/2952.
For the configuration of RADIUS, perform the following steps.
1. To add/delete an ISP domain, use command radius isp
<ispname> {enable|disable} in nas config mode. This is
shown in
Table 273.
TABLE 273 RADIUS ISP COMMAND
Format Mode Function
radius isp
<ispname>
{enable|disable}
nas config This add/delete an
ISP domain
Result: This add/delete an ISP domain.
Result
Purpose
Steps

Table of Contents

Related product manuals