Zte ZXR10 2928 User Manual

Chapter 8 Access Service
Confidential and Proprietary Information of ZTE CORPORATION 205
Port connecting to user network is called cascade port and port
connecting to BAS server is called trust port. Typical network
of VBAS is shown in
FIGURE 35 TYPICAL NETWORK OF VBAS
Configuring VBAS
This topic describes the configuration of VBAS.
For the configuration of VBAS, perform the following steps.
1. To enable/disable global VBAS function, use command
set vbas {enable|disable} in global configuration mode.
This is shown in
Table 342.
TABLE 342 SET VBAS COMMAND
Format Mode Function
set vbas
{enable|disable}
global config This enable/disable
global VBAS
function
Result: This enable/disable global VBAS function.
Note: VBAS function is disabled by default. This command
is to enable/disable VBAS globally.
2. To enable/disable trust port VBAS function, use
command set vbas trust-port <portlist> {enable|disable}
in global configuration mode. This is shown in
Table 343.
TABLE 343 SET VBAS TRUST PORT COMMAND
Format Mode Function
set vbas trust-
port <portlist>
{enable|disable}
global config This enable/disable
trust port VBAS
function
Result: This enable/disable trust port VBAS function.
Purpose
Steps

Zte ZXR10 2928 Specifications

General

MAC Address Table Size	16K
VLAN	4K
Jumbo Frame	9K
Power Supply	AC 100-240V, 50/60Hz
Power Consumption	< 30W
Dimensions	440mm x 200mm x 44mm
Operating Temperature	0°C to 45°C
Storage Temperature	-40°C to 70°C
Operating Humidity	10% to 90% non-condensing
Storage Humidity	5% to 95% non-condensing
Ports	24 x 10/100/1000Base-T ports, 4 x GE SFP ports