Zte ZXR10 2928 User Manual

Chapter 8 Access Service
Confidential and Proprietary Information of ZTE CORPORATION 199
1. To enable/disable IP source guard function based on port,
use command set dhcp ip-source-guard {add|delete}
port <portlist> in global configuration mode. This is shown
in
Table 331.
TABLE 331 SET DHCP IP SOURCE GUARD COMMAND
Format Mode Function
set dhcp ip-
source-guard
{add|delete} port
<portlist>
global config This enable/disable
IP source guard
function based on
port.
Result: This enable/disable IP source guard function based
on port.
2. To display IP source guard configuration, use command
show dhcp ip-source-guard in global configuration mode.
This is shown in
Table 332.
TABLE 332 SHOW DHCP IP SOURCE GUARD COMMAND
Format Mode Function
show dhcp ip-
source-guard
global config This displays IP
source guard
configuration
Result: This displays IP source guard configuration.
E
ND OF STEPS
IP source guard has been configured on ZXR10 2920/2928/2952.
Configuring DHCP Option82
This topic describes the Option82 configuration on ZXR10
2920/2928/2952.
For the configuration of Option82, perform the following steps.
1. To configure access-node-identifier, use command set
dhcp option82 ani <string> in global configuration mode.
This is shown in
Table 333.
TABLE 333 SET DHCP OPTION82 COMMAND
Format Mode Function
set dhcp option82
ani <string>
global config This configures
access node
identifier
Result: This configures access node identifier.
2. To enable/disable Option82 function based on port, use
command set dhcp option82 {add|delete} port
Result
Purpose
Steps

Zte ZXR10 2928 Specifications

General

MAC Address Table Size	16K
VLAN	4K
Jumbo Frame	9K
Power Supply	AC 100-240V, 50/60Hz
Power Consumption	< 30W
Dimensions	440mm x 200mm x 44mm
Operating Temperature	0°C to 45°C
Storage Temperature	-40°C to 70°C
Operating Humidity	10% to 90% non-condensing
Storage Humidity	5% to 95% non-condensing
Ports	24 x 10/100/1000Base-T ports, 4 x GE SFP ports