ZXR10 2920/2928/2952
(V1.0) Access Switch User Manual (Volume I)
190 Confidential and Proprietary Information of ZTE CORPORATION
One switch which supports GVRP also can send local information
of VLAN registration to other switches.
Configuring GARP
This topic describes the configuration of GARP.
For the configuration of GARP, perform the following steps.
1. To enable/disable GARP, use command set garp in
global configuration mode. This is shown in
Table 315.
TABLE 315 SET GARP COMMAND
Format Mode Function
set garp global config This enable/disable
GARP
Result: This enable/disable GARP.
Note: By default GARP is disabled.
2. To set timer of GARP, use command set garp timer
{hold|join|leave|leaveall} <timer_value> in global
configuration mode. This is shown in
Table 316.
TABLE 316 SET GARP TIMER COMMAND
Format Mode Function
set garp timer
{hold|join|leave|leaveall}
<timer_value>
global config This sets timer
of GARP
Result: This sets timer of GARP.
Note: There are four kinds of timer including hold timer,
join timer, leave timer, and leave all timer.
3. To show GARP information and timer setup status, use
command show garp in global configuration mode. This is
shown in
Table 317.
TABLE 317 SHOW GARP COMMAND
Format Mode Function
show garp global config This shows GARP
information and
timer setup status
Result: This shows GARP information and timer setup status.
Note: All timers which enable GARP must be exactly same
otherwise application protocol can’t work normally.
E
ND OF STEPS
Purpose
Steps