EasyManua.ls Logo

Zte ZXR10 2928 - Table 213 Set Qos Policer Parameters Command; Table 214 Set Qos Policer Parameters Command; Table 215 Set Qos Policer Parameters Command

Zte ZXR10 2928
341 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ZXR10 2920/2928/2952
(V1.0) Access Switch User Manual Volume I
138 Confidential and Proprietary Information of ZTE CORPORATION
TABLE 213 SET QOS POLICER PARAMETERS COMMAND
Format Mode Function
set bandwidth
geport <portlist>
ingress {{on rate
<2000-1000000> }
| off }
global config
This configures the
geport ingress
session
Result: This configures the geport ingress session of flux
monitor.
14. To configure the geport ingress session of the flux
monitor, use command set bandwidth geport <portlist>
ingress {{on rate <2000-1000000> } | off }in global
configuration mode. This is shown in
Table 203.
TABLE 214 SET QOS POLICER PARAMETERS COMMAND
Format Mode Function
set bandwidth
geport <portlist>
ingress {{on rate
<2000-1000000> }
| off }
global config
This configures the
geport ingress
session
Result: This configures the geport ingress session of flux
monitor.
15. To configure the geport egress session of the flux monitor,
use command set bandwidth geport <portlist> egress
{on rate <281-1000000> [burstsize <4-16380>]} |
off }in global configuration mode. This is shown in
Table
203.
TABLE 215 SET QOS POLICER PARAMETERS COMMAND
Format Mode Function
set bandwidth
geport <portlist>
egress {on rate
<281-1000000>
[burstsize <4-
16380>]} | off }
global config
This configures the
geport egress
session
Result: This configures the geport egress session of flux
monitor.
16. To configure the packet-type of geport ingress session of
the flux monitor, use command set bandwidth geport
<portlist> packet-type { unicast | nounicast | multicast
| broadcast } {enable | disable }in global configuration
mode. This is shown in
Table 203.

Table of Contents

Related product manuals