Zte ZXR10 2928 User Manual

Chapter 9 Network Management
Confidential and Proprietary Information of ZTE CORPORATION 255
Format Mode Function
specified member
switch
Result: This deletes configuration of specified member
switch.
6. To restart specified member switch, use command
reboot member {<idlist>|all} in privileged mode. This is
shown in
Table 424.
TABLE 424 REBOOT MEMBER COMMAND
Format Mode Function
reboot
member{<idlist>|all}
privileged mode This restarts
specified member
switch
Result: This restarts specified member switch.
E
ND OF STEPS
Access and control cluster members have been configured.
Displaying Cluster Configuration
This topic describes the display of cluster configuration and
cluster member information.
For the display of cluster configuration, perform the following
steps.
1. To display cluster configuration information, use
command show group in global config mode. This is
shown in
Table 425.
TABLE 425 SHOW GROUP COMMAND
Format Mode Function
show group global config This displays cluster
configuration
information
Result: This displays cluster configuration information.
2. To display candidate switches that can be added to
cluster, use command show group candidate in global
config mode. This is shown in
Table 426.
TABLE 426 SHOW GROUP CANDIDATE COMMAND
Format Mode Function
show group
candidate
global config This displays
candidate switches
that can be added
Result
Purpose
Steps

Zte ZXR10 2928 Specifications

General

MAC Address Table Size	16K
VLAN	4K
Jumbo Frame	9K
Power Supply	AC 100-240V, 50/60Hz
Power Consumption	< 30W
Dimensions	440mm x 200mm x 44mm
Operating Temperature	0°C to 45°C
Storage Temperature	-40°C to 70°C
Operating Humidity	10% to 90% non-condensing
Storage Humidity	5% to 95% non-condensing
Ports	24 x 10/100/1000Base-T ports, 4 x GE SFP ports