Chapter 7 Service Configuration
Confidential and Proprietary Information of ZTE CORPORATION 137
TABLE 210 SET QOS POLICER PARAMETERS COMMAND
Format Mode Function
set bandwidth
feport <portlist>
ingress session
<0-3> mgmt-no-
ratelimit {enable
| disable}
global config
This configures the
ingress session
mgmt-no-ratelimit
Result: This configures the ingress session mgmt-no-
ratelimit of flux monitor.
12. To configure the ingress session of the flux monitor, use
command set bandwidth feport <portlist> ingress
session <0-3> {enable | disable}in global configuration
mode. This is shown in
Table 203.
TABLE 211 SET QOS POLICER PARAMETERS COMMAND
Format Mode Function
set bandwidth
feport <portlist>
ingress session
<0-3> {enable |
disable}
global config
This configures the
ingress session
mgmt-no-ratelimit
Result: This configures the ingress session of flux monitor.
13. To configure the egress session of the flux monitor, use
command set bandwidth feport <portlist> egress {{on
rate <64-1000000>} | off}in global configuration mode.
This is shown in
Table 203.
TABLE 212 SET QOS POLICER PARAMETERS COMMAND
Format Mode Function
set bandwidth
feport <portlist>
egress {{on rate
<64-1000000>} |
off}
global config
This configures the
egress session
Result: This configures the egress session of flux monitor.
14. To configure the geport ingress session of the flux
monitor, use command set bandwidth geport <portlist>
ingress {{on rate <2000-1000000> } | off }in global
configuration mode. This is shown in
Table 203.