EasyManua.ls Logo

Zte ZXR10 2928 - Table 177 Set Stp Relay Command; Table 178 Set Stp Revision Command; Table 179 Set Stp Trunk Command; Table 180 Set Stp Trunk Linktype Command

Zte ZXR10 2928
341 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ZXR10 2920/2928/2952
(V1.0) Access Switch User Manual Volume I
120 Confidential and Proprietary Information of ZTE CORPORATION
TABLE 177 SET STP RELAY COMMAND
Format Mode Function
set stp relay
{enable|disable}
Global
config
This enables/disables STP
relay
Result: This enables/disables STP relay.
32. To set the MST version, use command set stp revision
<0-65535> in global configuration mode. This is shown in
Table 178.
TABLE 178 SET STP REVISION COMMAND
Format Mode Function
set stp revision <0-
65535>
Global
config
This sets the MST version
Result: This sets the MST version.
33. To enable/disable STP trunk, use command set stp
trunk <trunklist> {enable|disable} in global configuration
mode. This is shown in
Table 179.
TABLE 179 SET STP TRUNK COMMAND
Format Mode Function
set stp trunk
<trunklist>
{enable|disable}
Global
config
This enable/disable stp
trunk
Result: This enable/disable STP trunk.
34. To set trunk’s link type of the instance, use command
set stp trunk <trunklist> linktype {point-point|shared}
in global configuration mode. This is shown in
Table 180.
TABLE 180 SET STP TRUNK LINKTYPE COMMAND
Format Mode Function
set stp trunk
<trunklist> linktype
{point-
point|shared}
Global
config
This sets trunk link type of
the instance
Result: This sets trunk link type of the instance.
35. To set trunk packet type of instance, use command set
stp trunk < trunkid > packettype
{IEEE|CISCO|HUAWEI| HAMMER|extend}} in global
configuration mode. This is shown in
Table 181.

Table of Contents

Related product manuals