1-2
Figure 1-1 The Create tab
Table 1-2 describes the configuration items of creating a VLAN interface.
Table 1-2 Configuration items of creating a VLAN interface
Item Description
Input a VLAN ID:
Input the ID of the VLAN interface to be created. Before creating a VLAN
interface, make sure that the corresponding VLAN exists.
DHCP
BOOTP
Manual
Configure the way in which the VLAN interface gets an IPv4
address.
Allow the VLAN interface to automatically obtain an IP address
by selecting the DHCP or BOOTP option, or manually assign
the VLAN interface an IP address by selecting the Manual
option.
IPv4
Address
Configure an IPv4 address for the VLAN interface.
This option is available after you select the Manual option.
Config
ure
Primar
y IPv4
Addres
s
Mask
Length
Select the subnet mask length.
This option is available after you select the Manual option.
These
items are
available
after you
select the
Configure
Primary
IPv4
Address
check box.
Return to
VLAN interface configuration task list.
To Next Page
Loading...
