1-16
After the above configuration, make sure that the system clock of the Switch is synchronous to that of
the CA, so that the Switch can request certificates and retrieve CRLs properly.
2) Configure Switch
# Create a PKI entity.
z Select Authentication > PKI from the navigation tree. The PKI entity list page is displayed by
default. Click Add on the page, as shown in
Figure 1-16, and then perform the following
configurations as shown in
Figure 1-17.
Figure 1-16 PKI entity list
Figure 1-17 Configure a PKI entity
z Type aaa as the PKI entity name.
z Type ac as the common name.
z Click Apply.
# Create a PKI domain.
z Select the Domain tab, and then click Add, as shown in Figure 1-18, and then perform the
following configurations as shown in
Figure 1-19.
To Next Page
Loading...
