3Com Baseline 2928 PWR Plus - Page 443

1-3
Figure 1-3 Configure isolated ports for an isolation group
z Select Isolate port for the port type.
z Select GigabitEthernet 1/0/2, GigabitEthernet 1/0/3, and GigabitEthernet 1/0/4 on the chassis front
panel.
z Click Apply. A configuration progress dialog box appears.
z After the configuration process is complete, click Close in the dialog box.
# View information about the isolation group.
Click Summary. The page shown in
Figure 1-4 appears.
Figure 1-4 Information about port isolation group 1
As shown on the page, port isolation group 1 contains these isolated ports: GigabitEthernet 1/0/2,
GigabitEthernet 1/0/3, and GigabitEthernet 1/0/4.