3Com Baseline 2928 PWR Plus - Page 90

1-7
Configuration procedure
# Set the rate of GigabitEthernet 1/0/4 to 1000 Mbps.
z Select Device > Port Management from the navigation tree, click the Setup tab to enter the page
shown in
Figure 1-5, and make the following configurations:
Figure 1-5 Configure the rate of GigabitEthernet 1/0/4
z Select 100 in the Speed dropdown list.
z Select GigabitEthernet 1/0/4 on the chassis front panel.
z Click Apply to end the operation.
# Batch configure the auto-negotiation rate range on GigabitEthernet 1/0/1, GigabitEthernet 1/0/2, and
GigabitEthernet 1/0/3 as 100 Mbps.
z Select Auto 100 in the Speed dropdown list on the page shown in Figure 1-6.
z Select GigabitEthernet 1/0/1, GigabitEthernet 1/0/2, and GigabitEthernet 1/0/3 on the chassis front
panel.
z Click Apply to end the operation.