1-6
z Select 1 – Local in the Mirroring Group ID drop-down list.
z Select Mirror Port in the Port Type drop-down list.
z Select both in the Stream Orientation drop-down list.
z Select GigabitEthernet 1/0/1 and GigabitEthernet 1/0/2 on the chassis front panel.
z Click Apply. A configuration progress dialog box appears, as shown in Figure 1-7.
Figure 1-7 Configuration progress dialog box
z After the configuration process is complete, click Close.
# Configure the monitor port.
Click Modify Port to enter the page for configuring ports for the mirroring group, as shown in
Figure 1-8.
Figure 1-8 Configure the monitor port
z Select 1 – Local in the Mirroring Group ID drop-down list.
z Select Monitor Port in the Port Type drop-down list.
z Select GigabitEthernet 1/0/3 on the chassis front panel.
To Next Page
Loading...
