6. Slide the cable through the hole in the cable entry and attach the grommet to the
hole.
7. Connect the motor cable:
• Ground the shield 360 degrees by tightening the clamp of the power cable
grounding shelf onto the stripped part of the cable. (7a)
• If you need more working space, open the screw (7d) and lift the EMC plate
off. Remember to put it back after you have installed motor and input power
cables.
• Connect the twisted shield of the cable to the grounding terminal. (7b)
• Connect the phase conductors of the cable to the T1/U, T2/V and T3/W
terminals. Tighten the screws to the torque given in the table below (7c).
R3R1…R2
BRAKE RESINPUT
PE
MOTOR
R-
R+
UDC+
W/3TV/2TU/1T3L2L1L
7b7c
7a
MOTOR
T1/U T2/V T3/W
INPUT
L1 L2 L3
BRAKE RES
R-
R+
UDC+
PE
7b
7c
7a
Electrical installation – IEC 125
To Next Page
Loading...
