Materials
• PC/ABS 3 mm, PC+GF10 3mm, color NCS 1502-Y (RAL 9002
/ PMS 1C Cool Grey) and RAL 9002.
• hot-dip zinc coated steel sheet 1.5…2.5 mm, thickness of coating
100 micrometers, color NCS 1502-Y
Drive enclosure
Plywood, cardboard and molded pulp. Foam cushions PE, PP-E,
bands PP.
Package
The main parts of the drive can be recycled to preserve natural re-
sources and energy. Product parts and materials should be dis-
mantled and separated.
Disposal
Generally all metals, such as steel, aluminum, copper and its alloys,
and precious metals can be recycled as material. Plastics, rubber,
cardboard and other packaging material can be used in energy re-
covery. Printed circuit boards and large electrolytic capacitors need
selective treatment according to IEC 62635 guidelines. To aid recyc-
ling, plastic parts are marked with an appropriate identification code.
Contact your local ABB distributor for further information on environ-
mental aspects and recycling instructions for professional recyclers.
End of life treatment must follow international and local regulations.
Applicable standards
The drive complies with the following standards. The compliance with the European Low Voltage
Directive is verified according to standard EN 61800-5-1.
Safety of machinery. Electrical equipment of machines. Part 1:
General requirements. Provisions for compliance:
The final assembler of the machine is responsible for installing
EN 60204-1:2018,
EN 60204-1:2006 +
AC:2010
• emergency-stop device
• supply disconnecting device.
Semiconductor converters - General requirements and line commut-
ated converters - Part 1-1: Specification of basic requirements
IEC 60146-1-1:2009
EN 60146-1-1:2010
Degrees of protection provided by enclosures (IP code)
IEC 60529:1989 +
AMD1:1999 + AMD2: 2013,
EN 60529:1991 + A1:2000
+ A2: 2013
Electromagnetic compatibility (EMC) – Limits for harmonic current
emissions (input current > 16 A per phase)
IEC 61000-3-2:2018,
EN 61000-3-2:2014
Electromagnetic compatibility (EMC) – Limits for harmonic currents
produced by equipment connected to public low-voltage systems
with input current input current > 16 A and < 75 A per phase
EN 61000-3-12:2011
This drive complies with the standard provided that the short-circuit
power Ssc is greater than or equal to the minimum short-circuit
power given for the drive (listed for each drive type on page 302) at
the interface point between the user's supply and the public system.
It is the responsibility of the installer or user of the drive to ensure,
by consultation with the distribution network operator if necessary,
that the drive is connected only to a supply with a short-circuit power
Ssc greater than or equal to the minimum short-circuit power given
for the drive.
Technical data 299
To Next Page
Loading...
