ABB ACH580-01 - Reinstalling Side Plates and Covers, Frames R6; IP21 (UL Type 1); IP55 (UL Type 12)

￭ Reinstalling side plates and covers, frames R6…R9
IP21 (UL Type 1)
1. Reinstall the side plates of the cable box. Tighten the retaining screws with a T20
Torx screwdriver.
2. Slide the cover of the cable box on the module from below until the cover snaps
into place.
3. Reinstall the module cover. Tighten the two retaining screws with a screwdriver.
IP55 (UL Type 12)
1. Reinstall the module cover. Tighten the retaining screws with a T20 Torx screwdriver.
IP21 (UL Type 1)IP21 (UL Type 1)
2
1
Electrical installation – IEC 159