￭ Control panel LEDs
The control panel has one LED. The table below describes the control panel LED
indications. For more information see ACS-AP-I, -S, -W and ACH-AP-H, -W assistant
control panels user’s manual (3AUA0000085685 [English]).
Control panel LED, at the left edge of the control panel
LED blinking/flickeringLED lit and steadyLED off
Blinking:
Active warning in the drive
Flickering:
Data transferred between the PC
tool and drive through the USB
connection of the control panel
GreenDrive functioning normally.
Connection between the drive
and control panel may be faulty
or lost, or the panel and drive
may be incompatible. Check the
control panel display.
GreenPanel
has no
power
Active fault in the drive.
To reset the fault, cycle the drive
power.
RedCheck the display to see where
the fault is.
Red
• Active fault in the drive.
Reset the fault.
• Active fault in another drive
in the panel bus.
Switch to the drive in question
and check and reset the fault.
Panels with a Bluetooth interface
only.
Blinking:
Bluetooth interface is enabled. It
is in discoverable mode and
ready for pairing.
Flickering:
Data is transfered through the
Bluetooth interface of the control
panel.
Blue
228 Maintenance
To Next Page
Loading...
