ABB ACH580-01 - Terminal Layout for Frames R6-R9

To Next Page

To Previous Page

DescriptionTerm

Optional ControlNet™ adapter moduleFCNA-01

Optional DeviceNet™ adapter moduleFDNA-01

Optional EtherCAT® adapter moduleFECA-01

Optional Ethernet adapter module for EtherNet/IP™FEIP-21

Optional Ethernet adapter module for EtherNet/IP™, Modbus TCP® and

PROFINET IO® protocols, 2-port

FENA-21

Optional Ethernet POWERLINK adapter moduleFEPL-02

Optional LonWorks® adapter moduleFLON-01

Optional Modbus RTU adapter moduleFMBA-01

Optional Ethernet adapter module for Modbus TCP protocolFMBT-21

Optional PROFIBUS DP® adapter moduleFPBA-01

Optional PROFINET IO adapter moduleFPNO-21

Physical size of the drive or power moduleFrame, frame size

Optional RS-485 (Modbus/RTU) adapterFSCA-01

Insulated gate bipolar transistorIGBT

DC circuit between rectifier and inverterIntermediate circuit

Inverter module(s) under control of one control unit, and related components.

One inverter unit typically controls one motor.

Inverter unit

A networking platformLonWorks®

Remote monitoring toolNETA-21

With fieldbus protocols based on the Common Industrial Protocol (CIPTM),

such as DeviceNet and Ethernet/IP, denotes the control of the drive using

the Net Ctrl and Net Ref objects of the ODVA AC/DC Drive Profile. For

more information, see www.odva.org.

Network control

In the drive control program, user-adjustable operation instruction to the

drive, or signal measured or calculated by the drive.

In some (for example fieldbus) contexts, a value that can be accessed as

an object. For example, variable, constant, or signal.

Parameter

Programmable logic controllerPLC

Positive temperature coefficientPTC

Converts alternating current and voltage to direct current and voltageRectifier

Safe torque off (IEC/EN 61800-5-2)STO

Other manuals for ABB ACH580-01