ABB ACH580-01 - Cover and Hood Installation; Drive Cover Reinstallation Procedures; Protective Hood Installation

￭ External control connection terminals, frames R1…R5
The layout of the external control connection terminals of the R1 frame is shown below.
Layout of the external control connection terminals is identical in frames R1…R5 but
the location of the control unit with the terminals is different in frames R3…R5.
Description
Analog inputs and outputsX1
Aux. voltage outputX2
Programmable digital inputsX3
Safe torque off connectionX4
Embedded fieldbusX5
Relay output 3X6
Relay output 2X7
Relay output 1X8
Auxiliary fan connection (IP55)X10
Option slot 1 (fieldbus adapter mod-
ules)
X13
Option slot 2 (I/O extension modules)X14
Termination switch (S4), bias resistor
switch (S5), see Switches (page 143)
(IEC) or Switches (page 190) (North
America)
S4,S5
Panel port (control panel connection)1
Cold configuration connection. This
connector is used with the CCA-01
configuration adapter.
2
Power OK and Fault LEDs. See section
LEDs (page 227).
3
1
2
3
S4
X5
S5
X13
X14
X3
X2
X4
X1
X6
X7
X8
X10
R1…R5
Operation principle and hardware description 45