Note: The drive is shipped with grommet cones pointing up. They must be removed
and inserted back pointing down.
Motor cabling
5. Strip the ends of the conductors.
6. Slide the conductors through the conduit.
7. Connect the conductors:
• Connect the grounding conductor to the grounding terminal. (7a)
• Connect the phase conductors to the T1/U, T2/V and T3/W terminals (7b).
Tighten the screws to the torque given in the table.
R3R1…R2
Electrical installation – North America 175
To Next Page
Loading...
