SeeTask
Installation checklist (page 209)
Check the installation.
ACH580 HVAC control program firmware
manual (3AXD50000027537 [English])
Commission the drive.
Terms and abbreviations
DescriptionTerm
Assistant control panel with Hand-Off-Auto functionalityACH-AP-H
Assistant control panel with Hand-Off-Auto functionality and Bluetooth inter-
face
ACH-AP-W
A network protocol (Building Automation and Control Networks)BACnet™
Conducts the surplus energy from the intermediate circuit of the drive to
the brake resistor when necessary. The chopper operates when the DC
link voltage exceeds a certain maximum limit. The voltage rise is typically
caused by deceleration (braking) of a high inertia motor.
Brake chopper
Dissipates the drive surplus braking energy conducted by the brake chopper
to heat
Brake resistor
The capacitors connected to the DC linkCapacitor bank
Configuration adapterCCA-01
Communication adapter moduleCDPI-01
115/230 V digital input extension moduleCHDI-01
Multifunction extension module (external 24 V AC/DC and digital I/O exten-
sion)
CMOD-01
Multifunction extension module (external 24 V AC/DC and isolated PTC
interface)
CMOD-02
The part in which the control program runs.Control unit
Multifunction extension module (external 24 V and ATEX/UKEX-certified
PTC interface)
CPTC-02
DC circuit between rectifier and inverterDC link
Energy storage which stabilizes the intermediate circuit DC voltageDC link capacitors
Mounting platform for control panel (flush mounting)DPMP-01
Mounting platform for control panel (surface mounting)DPMP-02, DPMP-03
Optional mounting platform for door mounting of control panelDPMP-EXT
Frequency converter for controlling AC motorsDrive
Embedded fieldbusEFB
Electromagnetic compatibilityEMC
Fieldbus adapterFBA
BACnet/IP adapter moduleFBIP-21
Optional CANopen® adapter moduleFCAN
Introduction to the manual 29
To Next Page
Loading...
