Note: The drive is shipped with grommet cones pointing up. They must be removed
and inserted back pointing down.
Motor cable
4. Cut an adequate hole into the rubber grommet. Slide the grommet onto the cable.
5. Prepare the ends of the cable as illustrated in the figures. In frames R1 and R2
there are markings on the drive frame near the power cable terminals helping you
to strip the wires to the correct length of 8 mm.
Two different motor cable types are shown (6a, 6b).
Note: The bare shield will be grounded 360 degrees. Mark the pigtail made from
the shield as a PE conductor with yellow-and-green color.
124 Electrical installation – IEC
To Next Page
Loading...
