EasyManua.ls Logo

ABB ACH580-01 - CE Marking; Compliance with the European Low Voltage Directive; Compliance with the European EMC Directive; Compliance with the European ROHS II Directive 2011;65;EU

ABB ACH580-01
398 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
BTL (BACnet Testing Laboratories) mark
Product has BACnet conformance certificate.
RCM mark
Product complies with Australian and New Zealand requirements specific to EMC,
telecommunications and electrical safety. For fulfilling the EMC requirements, see the
additional information concerning the drive EMC compliance (IEC/EN 61800-3).
WEEE mark
At the end of life the product should enter the recycling system at an appropriate col-
lection point and not placed in the normal waste stream.
Note: The ACH580-01 230 V 3-phase R9 drives have NOT been verified to comply with
CSA, CE or IEC directives or any other world standards outside of North America.
CE marking
A CE mark is attached to the drive to verify that the drive follows the provisions of the
European Low Voltage, EMC and RoHS Directives.The CE marking also verifies that
the drive, in regard to its safety functions (such as Safe torque off), conforms with the
Machinery Directive as a safety component.
Compliance with the European Low Voltage Directive
The compliance with the European Low Voltage Directive has been verified according
to standard EN 61800-5-1:2007. The declaration of conformity (3AXD10000437232) is
available on the Internet. See section Document library on the Internet on the inside of
the back cover.
Compliance with the European EMC Directive
The EMC Directive defines the requirements for immunity and emissions of electrical
equipment used within the European Union. The EMC product standard (EN 61800-
3:2004 + A1:2012) covers requirements stated for drives. See section Compliance with
the EN 61800-3:2004 + A1:2012 below. The declaration of conformity
(3AXD10000437232) is available on the Internet. See section Document library on the
Internet on the inside of the back cover.
Compliance with the European ROHS II Directive 2011/65/EU
The RoHS II Directive defines the restriction of the use of certain hazardous substances
in electrical and electronic equipment. The declaration of conformity (3AXD10000437232)
is available on the Internet. See section Document library on the Internet on the inside
of the back cover.
Technical data 303

Table of Contents

Other manuals for ABB ACH580-01

Related product manuals