IP21 (UL Type 1)
4. Remove the front cover: Remove the fastening screws (4a) with a T20 Torx
screwdriver and lift the cover from the bottom upwards (4b) and then to the top side
(4c).
5. Attach the cable box to the drive frame.
6. Tighten the box nuts.
7. Slide the box cover from the bottom (7a) and tighten the retaining screws (7b).
8. Put the tabs at the top of the front cover in their counterparts on the housing and
then press at the bottom (8a) and tighten the retaining screws (8b).
4 5
6
4a
4b
4c
3×M5 (#10)
7
8
7a
7b
7b
8a
8b
80 Mechanical installation
To Next Page
Loading...
