3. Remove the shroud on the power cable terminals by releasing the clips with a
screwdriver (3a) and pulling the shroud out (3b).
4. Knock out holes in the shroud for the cabling to be installed.
5. Frames R8…R9: If you install parallel cabling, also knock out holes in the lower
shroud.
6. Remove the rubber grommets, if present, for the motor and input power cabling.
Remove the grommets for the control cabling when you are connecting them.
7. Attach the cable conduits for the motor and input cabling to the cable entry holes.
Motor cabling
8. Strip the ends of the conductors.
Electrical installation – North America 183
To Next Page
Loading...
