10. Install the cable box plate. Position the plate (10a) and tighten the screw (10b).
PE,
L1, L2, L3Frame size
lbf·ftN·mlbf·ftN·mMlbf·ftN·m
0.91.21.62.2M54.15.6R5
11. Reinstall the shroud on the power terminals by putting the tabs at the top of the
shroud in their counterparts on the drive frame (11a) and then pressing the shroud
in place (11b).
Finalization
12. Secure the cables outside the unit mechanically.
Electrical installation – IEC 133
To Next Page
Loading...
