IP55 (UL Type 12)IP21 (UL Type 1)IP21 (UL Type 1)
WARNING!
If you install the drive on any other system than symmetrically grounded TN-S
system, see see Grounding system compatibility check (page 166) if you have
to disconnect the EMC filter and ground-to-phase varistor.
2. Attach the residual voltage warning sticker in the local language next to the control
unit.
3. Remove the shroud on the power cable terminals by releasing the clips with a
screwdriver (3a) and pulling the shroud out (3b).
4. Remove the rubber grommets, if present, for the motor and input power cabling.
Remove the grommets for the control cabling when you are connecting them.
5. Attach the cable conduits for the motor and input cabling to the cable entry holes.
Electrical installation – North America 179
To Next Page
Loading...
