ABB ACS880 - Page 134

PageContentsGroup
389
A second set of parameter values for process PID control.
41 Process PID set 2
392
Settings for the internal brake chopper.
43 Brake chopper
395
Configuration of mechanical brake control.
44 Mechanical brake control
400
Settings for the energy saving calculators.
45 Energy efficiency
403
Speed supervision settings; actual signal filtering; general scaling
settings.
46 Monitoring/scaling settings
408
Data storage parameters that can be written to and read from using
other parameters’ source and target settings.
47 Data storage
411
Communication settings for the control panel port on the drive.
49 Panel port communication
415
Fieldbus communication configuration.
50 Fieldbus adapter (FBA)
424
Fieldbus adapter A configuration.
51 FBA A settings
426
Selection of data to be transferred from drive to fieldbus controller
through fieldbus adapter A.
52 FBA A data in
427
Selection of data to be transferred from fieldbus controller to drive
through fieldbus adapter A.
53 FBA A data out
428
Fieldbus adapter B configuration.
54 FBA B settings
430
Selection of data to be transferred from drive to fieldbus controller
through fieldbus adapter B.
55 FBA B data in
431
Selection of data to be transferred from fieldbus controller to drive
through fieldbus adapter B.
56 FBA B data out
432
Configuration of the embedded fieldbus (EFB) interface.
58 Embedded fieldbus
441
DDCS communication configuration.
60 DDCS communication
457
Defines the data sent to the DDCS link.
61 D2D and DDCS transmit
data
462
Mapping of data received through the DDCS link.
62 D2D and DDCS receive data
472
Motor and load feedback configuration.
90 Feedback selection
482
Configuration of encoder interface modules.
91 Encoder module settings
486
Settings for encoder 1.
92 Encoder 1 configuration
494
Settings for encoder 2.
93 Encoder 2 configuration
496
Control of the supply unit of the drive, such as DC voltage and reactive
power reference.
94 LSU control
499
Various hardware-related settings.
95 HW configuration
507
Language selection; access levels; macro selection; parameter save
and restore; control unit reboot; user parameter sets; unit selection;
data logger triggering; parameter checksum calculation; user lock.
96 System
519
Motor model settings.
97 Motor control
525
Motor values supplied by the user that are used in the motor model.
98 User motor parameters
528
Motor configuration settings.
99 Motor data
535
FSO-xx settings.
200 Safety
536
Distributed I/O bus settings.
206 I/O bus configuration
536
Distributed I/O bus settings.
207 I/O bus service
536
Distributed I/O bus settings.
208 I/O bus diagnostics
134 Parameters