ABB ACS880 - D2 D and DDCS Receive Data

Def / Type
FbEq 16b / 32b
DescriptionName / Range /
Selection
No.
Mapping of data received through the DDCS link.D2D and DDCS
receive data
62
See also parameter group 60 DDCS communication.
None / uint32(Follower only) Defines a target for the data received as
word 1 from the master through the master/follower link.
M/F data 1 selection62.1
See also parameter 62.25 M/F data 1 value.
0None.None
1Control Word (16 bits)CW 16bit
2Reference REF1 (16 bits)Ref1 16bit
3Reference REF2 (16 bits)Ref2 16bit
4Scaled velocity value.
Note: This selection should be chosen for the same data
word as was set to D2D velocity in the master.
M/F velocity
3032-bit position value.
Note: This selection should be chosen for the same data
word as was set to D2D position in the master. (The setting
will automatically reserve two consecutive data words.)
M/F position
See Terms and abbreviations (page 132).
Other
None / uint32(Follower only) Defines a target for the data received as
word 2 from the master through the master/follower link.
M/F data 2 selection62.2
See also parameter 62.26 M/F data 2 value.
For the selections, see parameter 62.1 M/F data 1
selection.
None / uint32(Follower only) Defines a target for the data received as
word 3 from the master through the master/follower link.
M/F data 3 selection62.3
See also parameter 62.27 M/F data 3 value.
For the selections, see parameter 62.1 M/F data 1
selection.
Follower SW / uint32Defines a target for the data received as word 1 from the
first follower (ie. the follower with node address 2) through
the master/follower link.
Follower node 2 data
1 sel
62.4
See also parameter 62.28 Follower node 2 data 1 value.
0None.None
26
Status word of the follower. See also parameter 60.18
Follower enable.
Follower SW
See Terms and abbreviations (page 132).
Other
None / uint32Defines a target for the data received as word 2 from the
first follower (ie. the follower with node address 2) through
the master/follower link.
Follower node 2 data
2 sel
62.5
See also parameter 62.29 Follower node 2 data 2 value.
For the selections, see parameter 62.4 Follower node 2
data 1 sel.
None / uint32Defines a target for the data received as word 3 from the
first follower (ie. the follower with node address 2) through
the master/follower link.
Follower node 2 data
3 sel
62.6
See also parameter 62.30 Follower node 2 data 3 value.
For the selections, see parameter 62.4 Follower node 2
data 1 sel.
462 Parameters