Hand/Auto macro
The Hand/Auto macro is suited to speed control applications where two external control
devices are used.
The drive is speed-controlled from the external control locations EXT1 (Hand control)
and EXT2 (Auto control). The selection between the control locations is done through
digital input DI3.
The start/stop signal for EXT1 is connected to DI1 while running direction is determined
by DI2. For EXT2, start/stop commands are given through DI6, the direction through
DI5.
The reference signals for EXT1 and EXT2 are connected to analog inputs AI1 and AI2
respectively.
A constant speed (by default, 300 rpm) can be activated through DI4.
￭ Default parameter settings for the Hand/Auto macro
Below is a listing of default parameter values that differ from those listed for the Factory
macro in Parameter listing (page 136).
Hand/Auto macro defaultParameter
1500.000
12.30 AI2 scaled at AI2 max
DI319.11 Ext1/Ext2 selection
In1 Start; In2 Dir20.6 Ext2 commands
DI620.8 Ext2 in1 source
DI520.9 Ext2 in2 source
DIIL20.12 Run enable 1 source
AI2 scaled22.12 Speed ref2 source
Follow Ext1/Ext2 selection22.14 Speed ref1/2 selection
DI422.22 Constant speed sel1
Acc/Dec time 123.11 Ramp set selection
Not selected31.11 Fault reset selection
114 Application macros
To Next Page
Loading...
