Terms and abbreviations
DefinitionTerm
Type of parameter that is the result of a measurement or calculation by the drive,
or contains status information. Most actual signals are read-only, but some (espe-
cially counter-type actual signals) can be reset.
Actual signal
(In the following table, shown on the same row as the parameter name) The default
value of a parameter when used in the Factory macro. For information on other
macro-specific parameter values, see chapter Application macros.
Def
Note: Certain configurations or optional equipment may require specific default
values.
These are labelled as follows:
(95.20 bx) = Default changed or write-protected by parameter 95.20, bit x.
(In the following table, shown on the same row as the parameter range, or for each
selection)
FbEq
16b / 32b
The scaling between the integer used in communication and the value shown on
the panel when a 16-bit value is selected for transmission to an external system.
The scaling is indicated for both 16-bit and 32-bit values. A dash (-) indicates that
the parameter is not accessible in that format.
The value is taken from another parameter.Other
Choosing “Other” displays a parameter list in which the user can specify the source
parameter.
Note: The source parameter must be of the real32 (32-bit floating point) type. To
use a 16-bit integer (for example, received from an external device in data sets)
as the source, data storage parameters 47.1 … 47.8 can be used.
The value is taken from a specific bit in another parameter.Other [bit]
Choosing “Other” displays a parameter list in which the user can specify the source
parameter and bit.
Either a user-adjustable operating instruction for the drive, or an actual signal.Parameter
Per unitp.u.
The value of the parameter.[parameter
number in
square brack-
ets]
132 Parameters
To Next Page
Loading...
