Terminal mode operation
111
1SVC 440 795 M1100
Close Terminal mode.
Press the * button to close the Terminal mode.
X Press the “*” button.
This returns you back to your local device.
X Press the ESC button twice.
The status display of the display system device is active.
The flashing star at the top right of the display is no longer
present.
If the display base module was fitted to the display module
in an energized state, the display must be reinitialized.
X Press the DEL and ESC button to reinitialize the display.
h
In Terminal mode, the display system device makes its
display and operating unit available to the connected
device. Only data for the display and the status of the
buttons is sent via the connection. This ensures that the
local data of the connected device is not destroyed in the
event of a communication fault.
STATION ID: 2
START MODE
h
The * button cannot be assigned to other tasks if you wish
to use Terminal mode in your application. Use the * button
to change from the visualization to the status display.
Otherwise the Terminal mode menu cannot be reached.
STATION ID: 2
START MODE
I ..345..89...
I P-
SA 06:47 ST
Q 2 4 STOP
To Next Page
Loading...
Need help?
General
