9
1SVC 440 795 M1100
About this manual
This manual describes the installation, commissioning and
programming (circuit diagram generation) of the display
system.
Specialist electrical training is needed for commissioning and
creating circuit diagrams. When controlling active
components such as motors or pressure cylinders, parts of
the system can be damaged and persons put at risk if the
display system is connected or programmed incorrectly.
Device designation This manual uses the following abbreviated designations for
different device models:
• Display system
• CL-AC2 for CL-LER.18AC2
• CL-DC2 for CL-LER.18DC2, CL-LET.20DC2
Reading conventions Symbols used in this manual have the following meanings:
X Indicates actions to be taken.
h
Attention!
Warns of the risk of material damage.
i
Caution!
Warns of the possibility of serious damage and slight
injury.
j
Warning!
Indicates the risk of major damage to property, or serious
or fatal injury.
h
Draws your attention to interesting tips and
supplementary information.
To Next Page
Loading...
Need help?
General
