ABB CL Series User Manual

Installation
62
1SVC 440 795 M1100
The respective relay coils are actuated in the display system
circuit diagram via the output relays Q 01 to Q 04 or S 01 to
S 06 (S 08). You can use the signal states of the output relays
as N/O or N/C contacts in the display system circuit diagram
for additional switching conditions.
The relay or transistor outputs are used to switch loads such
as fluorescent tubes, filament bulbs, contactors, relays or
motors. Check the technical thresholds and output data
before installing such devices (a chapter „Technical
data“,page 389).
Connecting relay outputs CL-LDR…
Figure: 46: Relay outputs CL-LDR…
0 V H, N
L1, L2, L3 (115/250 V h)
+24 V H
Q1
12
f 8 A/B 16
f
10 000 000
Q2
12
... ... ...
Q3
12
M
Q4
12
25 000
RL
24 V H
8A
115 V h 8A
230 V h 8 A
3A
3A
3A
1000 W
10 x 58 W

ABB CL Series Specifications

General

Manufacturer	ABB
Rated Control Supply Voltage (Us)	24 V DC
Mounting	DIN Rail
Category	Relays
Contact Configuration	SPDT
Coil Voltage	24 V DC
Operating Temperature	-40°C to +70°C
Electrical Life	100 Thousand Cycles
Output	Relay