ABB CL Series User Manual

Function blocks
167
1SVC 440 795 M1100
Operating modes of the transfer data block function
block
Inputs
The function block inputs
>I1, >I2 and >NO can have
the following operands:
•Constants
• Markers MD, MW, MB
• Analog inputs IA01 to IA04
– IA01: Terminal I7
– IA02: Terminal I8
– IA03: Terminal I11
– IA04: Terminal I12
• Analog output QA01
• Actual value …QV> of another function block
Specifying the marker range without offset
If MB, MW or MD markers are specified both at
>I1 and at
>I2, the number of markers defines the source or
destination range.
Specifying a marker range with offset
If you wish to work with an offset, specify one of the
following variables at function block input
>I1 or >I2:
•Constant,
• Actual value ..QV of a function block,
• Analog input IA...,
• Analog output QA..
The value at the input is taken as the offset to marker MB01.
Parameter Function
INI Initialise marker ranges
CPY Copy marker ranges

ABB CL Series Specifications

General

Manufacturer	ABB
Rated Control Supply Voltage (Us)	24 V DC
Mounting	DIN Rail
Category	Relays
Contact Configuration	SPDT
Coil Voltage	24 V DC
Operating Temperature	-40°C to +70°C
Electrical Life	100 Thousand Cycles
Output	Relay