2 Security
This chapter covers:
2.1 Target group 10
2.2 General safety instructions 10
2.3 Meaning of written warning notices and hazard symbols 12
2.1 Target group
The instructions in this documentation are directed at the following target group:
Skilled Person:
Skilled person is a term applied to persons who have training or experience in the equipment
technology, particularly in knowing the various energies and energy magnitudes used in the equipment.
Skilled persons are expected to use their training and experience to recognize energy sources capable
of causing pain or injury and to take action for protection from injury from those energies.
Skilled persons should also be protected against unintentional contact or exposure to energy sources
capable of causing injury.
Instructed Person:
Instructed person is a term applied to persons who have been instructed and trained by a skilled person,
or who are supervised by a skilled person, to identify energy sources that may cause pain and to take
precautions to avoid unintentional contact with or exposure to those energy sources.
Under normal operating conditions, abnormal operating conditions or single fault conditions, instructed
persons should not be exposed to parts comprising energy sources capable of causing injury.
2.2 General safety instructions
WARNING: Before starting to install and work with this device, read the Safety Instructions. This
device shall only be connected to power supplies compliant to EN60950-1, chapter 2.5 ("limited
power source").
2.2.1 General information
l
Keep this document for later reference.
l
Always pass this document on together with the product.
l
Also consider any additional country-specific, local safety standards or regulations concerning
project planning, operation, and disposal of the product.
Liability claim
l
Do not connect the device to the 230V supply network if it is damaged or any parts are missing.
l
Do not make any changes or modifications to the device unless they are expressly mentioned in
this manual and have been approved by the manufacturer.
l
Use only spare parts and accessories that have been approved by the manufacturer.
© Vanderbilt 2023 10 I-200572
08.12.2023
To Next Page