Acre SPC42 - 13 Soft Engineer Programming Via the Keypad

To Next Page

To Previous Page

13 Soft Engineer programming via the keypad

This section provides [Soft] Engineer programming options using the LCD keypad.

For each menu option, the keypad must be in Engineer programming:

1. Enter a valid Engineer PIN. (Default Engineer PIN is 1111. For more details, see Engineer PINs

on page59.)

2. Using the up/down arrow keys, scroll to the desired programming option.

3. It is also possible to select a programming option using the keypad digits, enter the Engineer

programming PIN plus the digit as shown in the table below.

If you change one of the programming options, the keypad displays UPDATED momentarily.

Number Name Description

1 SETTING Performs an Unset, Fullset or Partset on the system.

2 INHIBIT Displays a list of the Inhibited zones on the system.

3 ISOLATE Allows the engineer to isolate zones on the system. See Isolate

on page116.

4 EVENT LOG Displays a list of the most recent events on the system. See

Event Log on page117.

5 ACCESS

LOG

Displays a list of the most recent access to the system. See

Access Log on page117.

6 ALARM LOG Displays a list of recent alarms. See Alarm Log on page117.

7 CHANGE

ENG PIN

Allows the engineer to change the Engineer PIN. See Change

Engineer Pin on page118.

8 USERS Allows the engineer to add, edit or delete users. See Users on

page88.

9 SMS Allows the user to add, edit or delete SMS details for users. See

SMS on page118.