14.24 Door Control
This option allows you to control all the doors of the system.
1. Scroll to DOOR CONTROL and press SELECT.
2. Select the door which should be controlled and press SELECT.
3. Select one of the door states listed below as new door state and press SELECT.
NORMAL The door is in normal operation mode. A card with the corresponding
access rights is needed to open the door.
MOMENTARY The door is opened only for a timed interval to allow access.
LOCKED The door is locked. The door remains closed even if a card with the
corresponding access rights is presented.
UNLOCKED The door is unlocked.
14.25 SPC Connect
Add an SPC Connect ATS to set up a connection between a panel and the SPC Connect website
https://www.spcconnect.com. This enables a panel user to register and access their panel remotely
using the SPC Connect website. If SPC Connect is not enabled during the start up wizard sequence, you
can use this menu to add an SPC Connect ATS. If SPC Connect was enabled during start up, this menu
shows the Registration ID for a panel.
ADD If SPC CONNECT was disabled during the start up wizard, the ADD menu displays. Select
ADD to create an SPC Connect ATS. This allows a panel user to register their panel and
access their panel remotely using the SPC Connect website, https://www.spcconnect.com
REGISTRATION
ID
If SPC CONNECT was enabled during the start up wizard, the panel registration ID
displays. Provide this information to an end user to allow them to register their panel with
the SPC Connect website, https://www.spcconnect.com, for remote access to their panel.
COMPANY ID For future use.
DELETE To remove an SPC Connect ATS from a panel, select DELETE.
SPC42/52/53/63 – Installation & Configuration Manual Engineer programming via the keypad
© Vanderbilt 2023 121 I-200572
08.12.2023
To Next Page