Acre SPC42 - Supported Card Readers and Card Formats

l
GSM to Alarm Reporting Centre (ARC)
l
PSTN to Alarm Reporting Centre (ARC)
l
Ethernet to SPC Comm receiver software
l
GPRS to SPC Comm receiver software
GSM ARC PSTN ARC Ethernet GPRS
ATS Level ATS 2 ATS 2 ATS 6 ATS 5
Attenuation of PSTN
For a PSTN dialer, a CW1308 Internal Telecom or equivalent cable should be used to connect the
modem to the phone line. The cable length should be between 0.5–100m.
Attenuation of Ethernet
For Ethernet, a Cat 5 cable should be used with its length between 0.5–100m.
Attenuation of GSM
The field strength of the GSM signal needs to at least -95dB. Below this level the modem will flag a
low signal fault to the panel. This is handled in the same way as other faults on the system.
Monitoring and watchdog of PSTN (SPCN110) and GSM (SPCN320/SPCN340)
A failure of the interface between the PSTN modem and the panel will be detected after 30 seconds,
after which an ATS fault will occur.
A failure of the interface between the GSM modem and the panel will be detected after 30 seconds,
after which an ATS fault will occur.
21.17 Supported card readers and card formats
The following card readers and formats are supported on the SPC system:
Reader Card Format
HD500-EM
PR500-EM
SP500-EM
PM500-EM
IB41-EM
IB42-EM
IB44-EM
IB45-EM
ABR5100-BL
ABR5100-TG
ABR5100-PR
HD500-Cotag
PR500-Cotag
SP500-Cotag
PM500-Cotag
HF500-Cotag
IB928
IB911
IB968
IB961
IB958M
SPC42/52/53/63 – Installation & Configuration Manual Appendix
© Vanderbilt 2023 286 I-200572
08.12.2023