Acre SPC42 - Wireless

To Next Page

To Previous Page

Performable actions

Restore

Alerts

Click the button to restore all alerts on the panel.

Inhibit Click this button to inhibit a fault condition. The inhibit operation will disable that fault or zone for

one arming period only.

Inhibit operation is not available in Security Grade EN 50131 Grade 3.

Isolate Click this button to isolate that zone. Isolating a zone will de-activate that zone until such time as

the zone is explicitly de-isolated again. It is recommended that you exercise caution when

isolating zones as those zones will not be active every time the system is SET.

15.6.3 Wireless

Wireless sensor detection (868MHz) on the SPC panel is provided by wireless modules. There are

two types of wireless modules: one way SiWay RF Kit (SPCW120 or WRTX) and two way SPCW120

Wireless Transceiver. The SiWay RF Kit is fitted in the controller, on the keypad, or by installing a

wireless expander. The SPC two way wireless module is fitted into modem slot 2 of the control panel.

See the table below for information on which devices can be enrolled with each type of transceiver.

For CE regulatory compliance, the SPCW120 product can only be fitted to the following

products:

SPC42

SPC52

SPC53

SPC62

Devices compatible with a two way transceiver

Wireless

sensors

WPIR Wireless 12m PIR detector with pet immunity option

WPIR-CRT Wireless curtain PIR detector

WMAG Wireless magnetic contact (slim)

WMAG-I Magnetic contact with additional input

WRMT Remote control FOB with 4 button control

WPAN Wireless personal alarm button

WSMK Wireless smoke detector

WMAG-S Wireless shock sensor with door contact

WFLOOD Wireless flood sensor

WAGB Wireless acoustic glass break detector

WPIR-EXT Wireless external PIR detector

WSIR-INT Wireless internal sounder

WSIR-EXT Wireless external sounder

WRPTR Wireless signal repeater plug

WKPD Wireless keypad

SPC42/52/53/63 – Installation & Configuration Manual Engineer programming via the browser

08.12.2023