For instructional videos on wireless devices and transceivers please go to
http://van.fyi?Link=Wireless_devices.
15.9.1 Two way wireless
The following devices can be enrolled and configured on a two way wireless transceiver:
l
Wireless detectors (motion detectors, magnetic contacts, smoke alarms)
l
Wireless outputs (internal and external sirens)
l
Wireless repeaters
l
Wireless keypads
l
WPAN Personal alarm button
l
WRMT Remote control
Note: You must enable two way wireless before enrolling these devices.
To enable two way wireless:
1. Select Configuration > Hardware > Wireless > Wireless Settings.
2. Enable Two Way Wireless.
The SPCW120 Wireless Transceiver can support (up to) the following number of devices
l
64 detectors
l
16 output sirens
l
8 wireless keypads
l
4 repeaters
l
20 fobs (personal alarm buttons and/or remote controls)
To upgrade the transceiver firmware to version 4.7.x, you must ensure that no more than 20 fobs
(remote controls or personal alarm buttons) are configured on your SPC system. If there are
more than 20 fobs configured, delete any excess fobs.
The combined maximum number of synchronous devices (wireless keypads and sirens) should
not exceed 16 per transceiver.
15.9.1.1 Add wireless sensor
Add a wireless sensor using the browser
To add a wireless sensor using the browser:
1. Select Configuration > Hardware > Wireless Settings.
2. Enable Two Way Wireless.
3. Select Configuration > Hardware > Wireless > Two Way and click Enrol New Device.
SPC42/52/53/63 – Installation & Configuration Manual Engineer programming via the browser
© Vanderbilt 2023 150 I-200572
08.12.2023
To Next Page