3 Profile 3 is used with HID readers that send a PIN to the panel as a card reading with
a predefined site code (0 )
4 Profile 4 is used with HID readers that send a PIN to the panel as a card reading with
a predefined site code (255 ).
5 Select to enable Sesam readers. For VdS compliance, ensure you select the
Override Reader Profile option on the browser to provide feedback on the setting
process.
See also
Door Expander on page34
14.6.5 Addressing Mode
X-BUS addressing can be configured in one of the 2 following ways:
Automatic addressing
With automatic addressing, the controller over-rides rotary switches and automatically assigns
expanders and keypads in the system unique IDs in sequential order.
Manual addressing
Manual addressing allows manual determination of each expander/keypad ID in a system. All devices
should be installed where required and each ID set manually using the rotary switches. The zones to ID
can be calculated using the following formula: ((ID value X 8)+1)= first zone number and then the next 7
sequential zones. For example ((ID2 x 8)+1)=17. Zone 17 is allocated to input 1 on ID2. Each input has
the next sequential zone allocated to it, in this case up to zone 24.
Note: ID limit for zone allocation SPC 42: Expander ID 1–3. SPC 52/53: Expander ID 1–15. SPC 63:
Expander ID 1–63.
ID Zone ID Zone ID Zones ID Zones ID Zones
1 9-16 14 113-120 27 217-224 40 321-328 53 425-432
2 17-24 15 121-128 28 225-232 41 329-336 54 433-440
3 25-32 16 129-136 29 233-240 42 337-344 55 441-448
4 33-40 17 137-144 30 241-248 43 345-352 56 449-456
5 41-48 18 145-152 31 249-256 44 353-360 57 457-464
6 49-56 19 153-160 32 257-264 45 361-368 58 465-472
7 57-64 20 161-168 33 265-272 46 369-376 59 473-480
8 65-72 21 169-176 34 273-280 47 377-384 60 481-488
9 73-80 22 177-184 35 281-288 48 385-392 61 489-496
10 81-88 23 185-192 36 289-296 49 393-400 62 497-504
11 89-96 24 193-200 37 297-304 50 401-408 63 505-512
12 97-104 25 201-208 38 305-312 51 409-416
13 105-112 26 209-216 39 313-320 52 417-424
SPC42/52/53/63 – Installation & Configuration Manual Engineer programming via the keypad
© Vanderbilt 2023 87 I-200572
08.12.2023
To Next Page