Acre SPC42 - Configuring Communications; Communications Settings

15.11 Configuring Communications
This section covers:
15.11.1 Communications Settings 208
15.11.2 FlexC® 215
15.11.3 Reporting 235
15.11.4 PC Tools 243
15.11.1 Communications Settings
This section covers:
l
Configuring the networking services of the panel below
l
Ethernet on the next page
l
Configuring Modems on the next page
l
Serial ports on page215
15.11.1.1 Configuring the networking services of the panel
1. Select Communications > Communications > Services.
2. Configure the fields as described in the table below.
HTTP
Enabled
Select this option to enable the embedded web server on the panel.
HTTP Port Enter the Port number that the web server is 'listening' on. By default this
is set to 443.
TLS Enabled Select this option to enable encryption operation on embedded web
server. By default this is enabled. With TLS enabled, web pages can only
be accessed by using ‘https://’ prefix before typing the IP address.
Telnet
Enabled
Select this option to enable the Telnet server. (Default: Enabled)
Note: Using Telnet without a comprehensive knowledge can damage the
controller configuration; this should only be used if the user has sufficient
knowledge or is being instructed by someone with such knowledge.
Telnet Port Enter the number of the Telnet port.
GPRS DNS
Enabled
Select this option to use DNS over GPRS
SNMP
Enabled
Select this option to enable Simple Network Management Protocol
(SNMP). (Default: Disabled)
SNMP
Community
Enter the Community ID for the SNMP protocol. (Default : Public)
ENMP
Enabled
Choose an option from the dropdown list to enable Enhanced Network
Management Protocol (ENMP). (Default : Enabled in Full Engineer)
ENMP Port Enter the ENMP port number (default: 1287).
ENMP
password
Enter the password for the ENMP protocol.
SPC42/52/53/63 – Installation & Configuration Manual Engineer programming via the browser
© Vanderbilt 2023 208 I-200572
08.12.2023