Modem 1 Tick this box to allow SPC Connect PRO to connect over Modem 1.
15.11.4.2 SPC Manager
The SPC manager mode setting determines the number of digits for user PINs and therefore the
number of available PINs on a global system controlled by SPC Manager.
Mode41: 4-digit PIN enables 1,000 global users
Mode51: 5-digit PIN enables 10,000 global users
Mode61: 6-digit PIN enables 100,000 global users
Mode71: 7-digit PIN enables 1000,000 global users
Mode81: 8-digit PIN enables 10,000,000 global users
When you set an SPC Manager mode, additional zeros are added to the front of existing 4 or 5 digits
user PINs which modify the PIN for global use. For example, if Mode71: 7-PIN Digit is selected, 3
zeros are added to existing 4 digit PINs – 2222 will become 0002222.
To set the SPC Manager Mode:
1. Select Communications > PC Tools > SPC Manager.
2. Select the SPC Manager global user mode from the drop down list.
3. Click the Save button.
The mode cannot be saved if a conflict exists between a local existing user PIN and another
user PIN on the global system. An ‘Invalid PIN’ error is displayed.
4. Click the appropriate button to delete the PIN and save the new mode or change the PIN to the
randomly generated new PIN displayed and then save the new mode.
NOTICE: SPC Manager modes cannot be changed if global users exist on the system.
15.12 File Operations
To perform operations on the panel files and configuration:
l
Select File.
The following tabs are displayed:
Upgrade Options for upgrading the controller and peripheral firmware, and languages
on the panel. See File Upgrade Operations on the next page.
File
Manager
Options for managing the system configuration file and uploading and
downloading users data to and from the panel. See File Manager
Operations on page247.
Audio Upload an audio file to the SPC. Click Browse and click Upload to add the
audio file to the SPC. After upload, click the Test button to validate the audio
file.
Default Restores the SPC system to factory defaults.
NOTICE!The IP address is maintained for connecting to the web
interface after a factory default from the web page.
SPC42/52/53/63 – Installation & Configuration Manual Engineer programming via the browser
© Vanderbilt 2023 244 I-200572
08.12.2023
To Next Page