Acre SPC42 - Central Station

Menu Option Description
USSD GSM Modem only
Enter the Unstructured Supplementary Service Data (USSD) code for your service
provider in order to enable SMS-free credit checking for Pay As You Go SIMs. Note:
This feature is not universally available. Please check with your service provider.
CHECK SIM
CREDIT
Enable this feature to receive information on remaining credit balance for Pay As You
Go SIMs (where available from your service provider).
NETWORKMODE GSM (4G) only
Select the signal type that you wish to the modem to use:
l
2G Only This option enables connection to 2G networks only.
l
3G Only This option enables connection to 3G networks only
l
4G Only This option enables connection to 4G networks only.
l
Search 4G First This option forces the modem to connect to 4G networks where
available. If 4G is not available, the modem connects to 2G.
GSM Modem only
If SMS enabled and an incorrect PIN is sent to the SIM card three times, the SIM is blocked. In this
case, Vanderbilt recommend that the SIM is removed and unblocked using a mobile phone. If the
SIM is changed on the GSM module or if a SIM is used with a PIN, Vanderbilt recommend that the
PIN code is programmed before the SIM is placed in the SIM holder. This ensures that incorrect
PINs are not sent to the SIM. All power should be removed (AC mains and battery) when loading
the SIM card into the SIM holder.
14.13.4 Central Station
This section covers how to add, edit, and delete a central station , and how to make a test call.
See:
l
Add below
l
Edit on the facing page
l
Delete on the facing page
l
Make Test Call on the facing page
14.13.4.1 Add
To program the central station settings:
1. Scroll to CENTRAL STATION > ADD.
2. Press SELECT.
3. Select the desired programming option shown in the table below.
ACCOUNT ID This information should be available from the receiving station and is used
to identify users each time a call is made to the ARC.
ACCOUNT
NAME
Description of the Remote Alarm Receiving Centre.
PROTOCOL The communication protocol to be used (SIA, Contact ID, Fast Format).
SPC42/52/53/63 – Installation & Configuration Manual Engineer programming via the keypad
© Vanderbilt 2023 111 I-200572
08.12.2023