Acre SPC42 - System Alerts; Logs; System Log

Status of
ATPs within
ATS
This table shows each ATP in the ATS. For each ATP, the table shows
the ATP sequence number, the ATP name, the communications
interface, ATP Status, Last successful transmission, Network Log, ATP
Log and Test Call button.
Network Log: Click this button to show the network log.
ATP Log: Shows a list of poll transmissions. Click the Refresh button to
update the log. Click the Most Recent Last button to change the viewing
order. By default the most recent event displays first.
Manual Test button: Click this button to force a test call. The Event is
added to the event queue.
15.6.7 System alerts
1. Select Status > System Alerts.
The following table shows the information that is available.
Alert Description of the system alert.
Input The actual state of the alert that was detected on the panel (OK, Fault).
Status The programmed status of the system alert, that is, whether the alert has been isolated or inhibited. A
status value of OK is displayed if the alert condition has not been disabled in any way.
Performable actions
Refresh Click this button to update the status of the system alerts.
Restore Click this button to restore an alert on the panel
Inhibit Click this button to inhibit a fault condition. The inhibit operation will disable that fault or zone for one
arming period only.
Inhibit operation is not available in Security EN 50131 Grade 3.
Isolate Click this button to isolate the zone. Isolating a zone will de-activate that zone until such time as the
zone is explicitly de-isolated again. It is recommended that you exercise caution when isolating
zones as those zones will not be active every time the system is SET.
15.7 Logs
This section covers:
15.7.1 System Log 137
15.7.2 Access Log 138
15.7.3 ALARM LOG 138
15.7.1 System Log
This log displays all the system events of the SPC system.
1. Select Log > System Log > System Log.
2. Create a text file of the log by clicking Text File.
3. The logging of individual zone state changes is enabled by setting the log attribute for that zone in
the Zone Attributes configuration page.
SPC42/52/53/63 – Installation & Configuration Manual Engineer programming via the browser
© Vanderbilt 2023 137 I-200572
08.12.2023