EasyManua.ls Logo

Acre SPC42 - ATS Category Timings

Acre SPC42
297 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Command Filter Commands
Verification Commands Read a Camera Image
Get the Status of a Verification Zone
Get the data for a Verification Zone
Send data to a Verification Zone
Get a camera image
Virtual Keypad Commands Control keypad
File Commands Upgrade the Panel Firmware
Upgrade Peripheral Firmware
Upload Peripheral Firmware
Upgrade PFW Progress
Upload a File
Download a File
Saves the Panel Configuration
Reset the Panel
Legacy Commands Get Panel Info
Get Panel Status
Get Headers of Configuration Files
Get Language Configuration
Get Intruder Configuration
Get Status of X-BUS Devices
Reconfiguration Xbus
Get the Area Configuration
21.20 ATS Category Timings
This table describes the EN50136-1 ATS Category Timings laid down in the standard and how the
FlexC implementation meets these standards under the categories SP1-SP6, DP1-DP4.
EN50136-1 ATS Category Timing
Requirements
FlexC Implementation of ATS Category
Timing Requirements
ATS
Category
Default
Interfaces
Event
Timeout
Primary
Polling
Timeout
Backup
ATP
Polling
Timeout
(Primary
OK)
Backup
ATP
Polling
Timeout
(Primary
Down)
Event
Timeout
Primary
Polling
Timeout
Backup
ATP
Polling
Timeout
(Primary
OK)
Backup
ATP
Polling
Timeout
(Primary
Down)
SP1 Cat 1
[Ethernet]
8 min 32 days - - 2 min 30 days - -
SPC42/52/53/63 Installation & Configuration Manual Appendix
© Vanderbilt 2023 292 I-200572
08.12.2023

Table of Contents