Acre SPC42 - Delete

To Next Page

To Previous Page

Attribute Description

Priority Priority cards are stored locally in the door controllers and will grant access in case of a

technical fault where the door controller cannot communicate with the control panel.

The maximum number of priority users is:

SPC42 – all users

SPC52/53 – 512

SPC63 – 512

Escort The escort feature enforces privileged card holders to escort other card holders through

specific doors. If this feature is enabled on a door, a card with the “escort” right has to be

presented first, to allow other cardholders without this right to open the door. The time period in

which cardholders are able to present their cards after a card with escort right was presented,

can be configured per door.

Custodian The custodian feature enforces a card holder with custodian privilege to always be inside a

room (door group) when other card holders are inside.

The custodian must be the first to enter the room. Only if a custodian is in the room other

cardholders are allowed to enter. The cardholder with the custodian right will not be allowed to

exit until all non-custodian cards left the room.

Identifies this card holder as a custodian. The user with the custodian attribute has to be the

first who enters a door group which requires a custodian card holder and has to be the last that

is leaving this door group.

Delete Card

If an access card is no longer needed it can be deleted via the keypad.

1. Scroll to DELETE CARD.

2. Press OK.

Reset Card

If the ‘Prevent Passback’ feature is activated in a room and a user leaves this room without using the exit

reader, he is not allowed to enter this room again. The user’s card can be reset to allow him to present

his card once without a passback check.

To reset the card via the keypad:

1. Scroll to RESET CARD.

2. Press OK.

14.7.3 Delete

To delete users on the system:

1. Scroll to USERS>DELETE.

2. Press OK.

A prompt displays, confirming command to delete.

3. Press YES to delete the user.

SPC42/52/53/63 – Installation & Configuration Manual Engineer programming via the keypad

08.12.2023