Acre SPC42 - Areas

Timer Description Default
Frequent
FREQUENT
This attribute only applies to remote services. The number of
hours within which a zone must open if the zone is programmed
with the Frequent attribute. (1–9999 hours)
336 h (2
weeks)
Duress silent Time when duress will remain silent and not restorable from
keypad. (0–999 minutes)
0 min.
Holdup/panic silent Number of minutes that a holdup/panic will remain silent and
cannot be restored from the keypad. (0–999 minutes)
0 min.
Default times are dependent upon the Engineer configuration. The default times denoted may or
may not be allowable and is dependent on the configuration by the engineer.
Valid settings/ranges may be dependent on the security grade specified under Configuration >
System > Standards.
14.4 Areas
1. Scroll to AREAS and press SELECT.
2. Scroll to the desired programming option:
ADD For Domestic and Commercial Mode, the area type defaults to Standard.
In Financial Mode, select area type STANDARD, ATM, VAULT or ADVANCED.
Enter the name of the area and the preferred entry/exit time.
SPC42/52/53/63 – Installation & Configuration Manual Engineer programming via the keypad
© Vanderbilt 2023 75 I-200572
08.12.2023