15.3 Connecting to the panel via USB
If the panel is reset while the USB cable is connected, the cable must be unplugged and plugged
in again.
The USB port on the controller connects to a PC via a standard Micro USB type cable. Drivers must
be installed to make a USB connection from the controller to the PC.
Prerequisites
o
You must have a USB cable connecting your PC to the panel.
1. Connect the USB cable from the controller to a USB interface on the PC.
The Found New Hardware wizard is displayed.
2. Click Next.
Windows detects a Generic USB hub.
3. Click Finish.
Windows detects the SPC – Advanced Security System on COM port N, where N is the
number of the COM port assigned to the device.
4. Make a note of the COM port assigned to the device, it is required later in the process.
The Found New Hardware wizard is displayed again.
5. Select Install the software automatically.
6. If the Windows driver installation wizard asks you to select the best match from a list, choose
the following option:
Vanderbilt Intrunet SPC USB Local Connection
7. Click Next.
A dialog box regarding Windows certification appears. Vanderbilt deems this acceptable to
continue. For further queries, contact your network administrator or a Vanderbilt technician.
8. Click Continue Anyway.
The installation finishes.
9. Click Finish.
The driver is installed.
15.4 Logging into the browser
To log into the browser:
1. When an Ethernet or USB link is established and the IP address of the controller determined,
open the PC browser.
2. Enter the IP address in the address bar of the browser using the hyper text transfer protocol
secure. (For example, http://192.168.1.100.) See the table in Default setting for WEB server
address on the next page.
A page with a security message is displayed.
3. Click Continue to this website.
The login page is displayed.
SPC42/52/53/63 – Installation & Configuration Manual Engineer programming via the browser
© Vanderbilt 2023 124 I-200572
08.12.2023
To Next Page